微振在線粘度計在使用時,須注意以下幾點
更新時間:2022-07-21 | 點擊率:711
微振在線粘度計適用于在石油石化、熱熔膠、聚胺樹脂、不飽和樹脂、絕緣漆、食用化工、玻璃化纖、油漆、防水涂料、有機硅、乳膠塑料、擠塑機、玻璃、絕緣漆、民爆、科研機構等各種行業。
根據其測量原理,為了獲得準確可靠的測量數據必須注意以下幾點:
1、微振在線粘度計的性能指標必須滿足國家度要求。使用中的儀器要進行周期檢定,必要時(儀器使用頻繁或處于合格臨界狀態)要進行中間自查以確定其計量性能合格,系數誤差在允許范圍內,否則無法獲得準確數據。
2、特別注意被測液體的溫度。許多用戶忽視這一點,認為溫度差一點無所謂,我們的實驗證明:當溫度偏差0.5℃時,有些液體粘度值偏差超過5%,溫度偏差對粘度影響很大,溫度升高,粘度下降。所以要特別注意將被測液體的溫度恒定在規定的溫度點附近,不要超過0.1℃。
3、測量容器(外筒)的選擇。對于雙筒要仔細閱讀儀器說明書,不同的轉子(內筒)匹配相應的外筒,否則測量結果會(huì )偏差巨大。對于單一圓筒旋轉粘度計,原理上要求外筒半徑限大,實際測量時要求外筒即測量容器的內徑不低于某一尺寸。
4、正確選擇轉子或調整轉速,使示值在20~90格之間。該類儀器采用刻度盤加指針?lè )绞阶x數,其穩定性及讀數偏差綜合在一起有0.5格,如果讀數偏小如5格附近,引起的相對誤差在10%以上,如果選擇合適的轉子或轉速使讀數在50格,那么其相對誤差可降低到1%。如果示值在90格以上,使游絲產生的扭矩過大,容易產生蠕變,損傷游絲,所以一定要正確選擇轉子和轉速。